When cutting the supply line cut slowly and gently so.
Installing refrigerator water line shut off valve.
Connect the refrigerator water line to the third outlet of the tee fitting.
A refrigerator water shut off valve should be installed on a cold water pipe because you don t want to feed your ice maker or water dispenser with hot water.
A refrigerator water valve is an important component of most refrigerators that have an icemaker water dispenser or both.
Turn off the water.
If it has a lever type handle turn the lever so it is perpendicular to the water pipe.
Install into the existing supply line.
Amazon s choice for ice maker water line shut off valve john guest speedfit ppsv040808wp straight shutoff valve plumbing fitting 1 4 x 1 4 inch 4 7 out of 5 stars 411.
1 close the cold water shut off valve leading to the kitchen sink.
It is often recommended to use a large.
Deburr the pipe with a deburring tool.
Tapping a sink without a valve.
Locate the fixture shutoff valve on the cold water supply line under the kitchen sink.
Self piercing saddle valves are designed to fit on copper or brass pipes and cannot be used with pex water pipe according to natural handyman.
Refrigerator water line to the stop valve with a compression joint.
Cut the supply line with a pipe cutter leaving enough room between the escutcheon plate and the cut to allow installation of the valve fitting.
Once you locate the refrigerator water line shut off valve pause.
When you re ready to shut off the valve simply turn it in.
The first step to ice maker installation or any supply line plumbing is to shut off the main valve to the house and open the lowest tap on the property to empty the pipes.
You should find the shut off valve when you arrive at the source.
Turn off the next valve up the line which may be the main water supply valve.
Ensure the valves inlets.
Place a bucket under the old valve.
Prior to shutting off the valve it s a good idea to turn off the icemaker because otherwise it will continue to cycle on which can damage the valve.
Don t use a saddle tee valve for an icemaker or water filter.
Then attach the tubing to the back of the cabinets every 2 to 4 ft.
Turn on the cold water at the kitchen faucet to relief pressure in the water line.
Find the line supplying the kitchen and cut out a section of the pipe no longer than 2 inches.
Use either a self tap saddle valve or a tee stop valve.
Since most refrigerators now have an automatic ice maker or a water dispenser it is important to know where to locate the refrigerator water valve in order to properly shut it off during needed repairs.
Once you re outside the last cabinet don t attach any clamps.
If your sink does not have a shut off valve you will have to tap the line through the sink s piping and install a valve for the refrigerator water line.
Next attach the 1 4 in.
Close the shutoff valve by turning it clockwise until it stops.