Repair upgrade your vinyl siding corners and add curb appeal and market value to your home.
Installing corners on vinyl siding.
Aviation and tin snip start cutting at the top interlock and continue toward the bottom of the panel.
Power saw bench or radial arm saw use a fine tooth blade with slow cutting movements.
These tips will help you to do a professional installation of your vinyl siding.
Always refer to the installation guide on the particular vinyl siding that you re installing but most vinyl siding panels should overlap each other by at least an inch.
Siding must be cut in lengths to provide for expansion.
The corner posts should run from 3 4 inch 1 9 cm below the bottom of the starter strip to just beneath the eaves after the soffit pieces have been installed.
To prevent this put flashing about one foot on each side of the corner.
When installing in freezing weather below 4 c.
Rigid foam sheathing to both sides of the corners and nail the corner trim over these strips.
Choose the right nails allow approximately 1 16 in.
Allow a 1 4 inch gap for expansion wherever siding butts accessories.
On hot days because the siding will contract when the temperature drops.
Install 1 2 inch 12 7 mm foam sheathing strips on both sides of each corner then install your corner siding pieces to these strips.
Then install the corner posts over the flashing.
Vinyl siding must be nailed so expansion and contraction are not restricted.
Utility knife score panel with knife then bend the vinyl back and forth until it snaps cleanly on the scored line.
Best way to cut vinyl siding and installation.
The corners of vinyl siding are one area where moisture can get in under the siding.
Vinyl siding installation is designed to hang loosely on the sheathing so that it can expand and contract with temperature changes.
Nail strips of 1 2 in.
To prevent the relatively thin panels from buckling observe these fitting and nailing rules.
Gap at all ends.